- 8 -
• Close the water fill opening 2 to the water tank 1.
Ensure that the lug on the water fill opening 2
sits in the indentation on the lid. Only in this way
is the water tank 1 properly closed.
• Replace the water tank 1 back onto the appliance.
The water tank 1 must audibly engage with the
unlocking device for the water tank 4.
Attaching/detaching the brush
attachment
Attention!
NEVER attempt to attach or detach the brush attach-
ment w when the appliance is heated up. Risk of Burns!
• To use the steam and brush function, place the
brush attachment w onto the steam brush.
• To do this, slide the brush attachment w all the
way along the guide to the end. The unlocking
device of the brush attachment q must engage
audibly.
• To be able to use the ironing function, remove
the brush attachment w from the steam brush.
• To do this, press the unlocking device q down-
wards and, at the same time, pull the brush attach-
ment w away to the front.
Steam brush function
• Place the brush attachment w onto the applian-
ce. This must engage audibly with the unlocking
device on the brush attachment q.
• Insert the power plug 7 into a correctly installed
and earthed mains power socket.
• To generate steam, set the temperature regulator
3 to at least ••• or higher. The heating-up con-
trol lamp 5 glows. As soon as the set temperature
has been reached, the heating-up control lamp
5 goes out.
Note:
For the steam blast function, set the temperature
regulator 3 to at least •••.
At lower settings the temperature is not sufficient to
generate a steam blast.
• By pressing the steam blast button 8 you can
now produce jets of steam.
Note:
To release the first steam blast after heating the
appliance up, it can happen that you may need
to press the steam blast button 8 several times in
succession.
The appliance is now ready for use.
Attention!
The steam brush can be used with all clothing items.
Caution is to be exercised with heat-sensitive materials
such as synthetics, polyamides or artificial silk. With
these materials you should first check at a concealed
part (inside seam) that the hot steam will not cause
any damage to the garment. Do not touch these ma-
terials directly with the hot sole of the iron 0. Use
only the steam blast.
Clothing care
• Suspend the crumpled garment from a coat hanger.
• With one hand pull the garment flat, then steam it
from top to bottom. The combination of steam and
clothes brush r will gently remove all creases.
• Use light pressure with the clothes brush r and
guide the appliance from top to bottom over the
garment. You can thereby press the steam blast
button 8 in short intervals.
Note:
You can repeatedly press the steam blast button 8
until the heating-up control lamp 5 glows or water
drips from the sole of the iron 0.
Then, wait until the heating-up control lamp 5 extin-
guishes before activating a further blast of steam.