2
A
B
C
D
F
E
CDA
B
99304, Rev F, ML, Ass Instr, Back support, Nov23
7mm
ASSEMBLY INSTRUCTIONS
Back support
Carl-Oskar, Rebel and Parade
Art. no: 10621 57-67cm
Art. no: 10655 72cm
Assembling
The back strap can be adjusted to different
lengts
Fold both ends of the back strap (so they
overlap each other) until preferred length is
achieved.
Draw the radius and the holes on the
underlying part and cut it along the marking.
Control measure the new end. The distance
from the hole to the radius shall be 7mm.
The back rest comes with the following parts:
A: Holder (2st)
B: Holder (2st)
C: Screw M4x14 (4st)
D: Screw M4x20 (4st)
E: Nut M4 (8st)
F: Back strap (1st)
Assembling of the back rest to the rollator
Place the holders (A and B) to the pipe, where the bending begins,
and put the end of the back strap between them.
Push the strap against the holder A so the two protruding cylinders
pushes through the straps hole. Press the two holders against each
other and tighten with the screws. The screw C is for the front
holes where the back strap is xed. The screw D is for the rear
holes.
Notice! Don’t tighten the screws too tight.
Notice!
Pay attention to cracks and loose
parts. Make sure the back sup-
port is rmly tightened by
pulling it.
The rollator must NOT be
hanged, carried or lifts in its
back rest.
• Årstaängsvägen 21B, SE-117 43 Stockholm, Sweden •
• Tel. +46(0)8 - 510 132 00 • Fax +46(0)8 - 665 35 10 •
• www.humancaregroup.com •