- 3 -
Before the First Use
• Remove all packaging materials from the appliance.
• Wipe the baking plate 1 with a moist cloth.
• Place the base 4 on a heat resistant and level
surface.
• Position the baking plate 1 on the base 4 so
that it sits well and is stable.
• Connect the plug 2 to a mains power socket.
The control lamp 8 glows.
Note:
If you set the thermostat 7 at "0" the green control
lamp "Ready" 9 glows constantly. In this way you
can check that the green control lamp "Ready" 9
is functioning. The appliance is not heated up in this
position.
• Adjust the thermostat 7 to MAX and allow the
appliance to heat up for approx. 10 minutes.
The red and green control lamps 8 9 glow.
Note:
On the first usage, the generation of light smoke and
a slight smell can occur, this is due to production re-
sidues. This is completely normal and is not dangerous.
Provide for sufficient ventilation, for example, open a
window.
• Place the thermostat 7 back to “0” and remove
the plug 2 from the mains power socket. The
control lamps 8 9 extinguish.
• Allow the appliance to cool down and once
again wipe the baking plate 1 with a moist
cloth.
The appliance is now ready for use.
Baking crêpes
1. Insert the power plug 2 into a wall socket.
The control lamp 8 glows.
2. Place the thermostat 7 at the desired heating
level. The higher the temperature level, the darker
the crêpes. Wait until the green control lamp
"Ready" 9 glows. This indicates that the appli-
ance is heated up.
3. Place a scoop full of pastry onto the baking
plate 1.
Note:
You can determine the browning of the crêpe with
the help of the thermostat 7 or with the baking
time.
Note:
To determine the correct volume of pastry, put as
much pastry onto the baking plate 1 as is required
to cover it to about 2/3 of its area. Make certain
that the pastry does not run over the edge of the
baking plate 1 surface. As required, reduce or in-
crease the volume of pastry for the next crêpe.
4. Briefly dip the pastry spreader 6 in water.
5. Using the pastry spreader 6, evenly spread
the pastry over the baking plate 1:
Place the pastry spreader 6 without pressure
onto the pastry and then spread it in a circle
from the center of the baking plate 1 to the
edge. The pastry should only be spread thinly
over the baking plate 1.
Note:
After every use, dip the pastry spreader 6 in water.
This allows the pastry to be better spread.
6. After about 45 seconds (depending on the
desired degree of browning), turn the pastry
with the help of the crêpe turner 5.
IB_53199_SCM1400A1_LB3 14.06.2010 15:22 Uhr Seite 3