SAFETY REGULATIONS
- The apparatus may only be connected to the mains equipped with standard,
single-phase earth wire! In case of any irregularity during operation, disconnect
the device from the mains immediately!
- Any maintenance may be done only on the apparatus disconnected from the
mains, with the connector plug being removed from the socket.
- DO NOT operate the pump dry!
- DO NOT replace the mains connection cable of the device home. In case of
failure of the connection cable, it can be replaced only by the repair service
shops listed in the list of Services, to the cable of the same quality as the
original one!
- DO NOT use the device with assembly connector plug!
- Any repair involving disassembly of the motor may exclusively be done by a
technician or specialised repair service shop! Following the repair, the pump
should be subjected to tightness test. The completion of the tightness test
should be proven in writing by the technician or the specialized repair service
shop performing the repair!
- Make sure that the voltage and frequency indicated in the data plate of the
pump are the same as those of the supply mains!
- The persons responsible for the installation must ascertain of whether the
electrical mains are equipped with effective earth wire in accordance with the
current norms!
- It is obligatory to install a highly sensitive leak current protective switch
in the electrical power supply system (Fi relay 30mA DIN VDE
01100T739)!
- Failing to keep to the regulation involves risk of electric shock!
- Failing to keep to the regulation may result in serious risk to the personal and
material safety!
- Failing to keep to the regulations may result in the damage of the pump or the
equipment!
Attention! This apparatus may be applied only in households, for domestic
purposes!
Contents
Chapter 1: General information
Chapter 2: Application limits
Chapter 3: Start-up, usage
Chapter 4: Technical data
Chapter 5: Maintenance, troubleshooting
Chapter 1: General information
The pump is equipped with floating switch, so it is suitable for automatic operation.
You can adjust the turn on/turn off level by sliding the cable of the floating switch in
the nest formed in the handle. The pump is protected by the suction strainer from
greater contaminants’ getting in the area of the blade wheel (wheels), and the
strainer hinders the blade from causing personal injuries.