8 GB
immediately the affected areas with fresh wa-
ter and seek medical attention!
WEAR PROTECTIVE GLOVES!
Leaked or damaged batteries /
rechargeable batteries can cause
burns on contact with the skin. Wear suitable
protective gloves at all times if such an event
occurs.
In the event of a leakage of batteries / recharge-
able batteries, immediately remove them from
the product to prevent damage.
Remove batteries / rechargeable batteries if the
product will not be used for a longer period.
Risk of damage of the product
Only use the specified type of battery /
rechargeable battery!
Insert batteries / rechargeable batteries accord-
ing to polarity marks (+) and (-) on the battery /
rechargeable battery and the product.
Use a dry lint-free cloth or cotton swab to clean
the contacts on the battery / rechargeable
battery and in the battery compartment before
inserting!
Remove exhausted batteries / rechargeable
batteries from the product immediately.
Functioning
The solar panel 6 installed in the product converts
sunlight into electrical energy and stores it in the
rechargeable battery.
The product will automatically light on as it begins
to get dark. The LEDs are a very long-life and en-
ergy-saving light source. The light duration depends
on the amount of sunlight, the angle of light on the
solar panel 6 and the temperature (the recharge-
able battery capacity is temperature-dependent).
A vertical angle of light at temperatures above the
freezing point is ideal. The rechargeable battery
does not achieve maximum capacity until after
several charge and discharge cycles.
In summer a completely drained rechargeable
battery takes about 2 to 4 days to fully recharge
in constant sunlight.
Before use
Note: Remove all packaging materials from the
product.
Installation (see Fig)
1. Push the ground spike 3 into the ground spike
attachment 2.
2. Slide the solar panel housing 1 over ground
spike attachment 2 if this has not been
pre-installed.
3. Push the ground spike 3 for enough into the
ground (lawn, flower bed) so it is firmly posi-
tioned upright in the ground.
4. Make sure it is firmly positioned. Do not use
any force when assembling or setting up the
product, e.g. hammer blows. This will damage
the product. For optimal results, set up the prod-
uct in a location where the solar panel 6 is
exposed to sunlight for the longest possible
amount of time. Do not put the product under
bushes, trees, canopies etc. as this reduces
the incidence of incoming sunlight. Position the
product in such a way that the solar panel 6
is not covered or in the shade.
Note: Make sure the solar panel 6 is not
impacted by other light sources, e.g. yard- or
street lighting, or the product will not switch
on at twilight.
5. You can fix the LED light bulb 4 on a desired
surface, twist on a tree or railing by using the
mounting material such as cable tie (mounting
material is not included).
Switching the product
1. Switch the ON / OFF switch 5 in the ON
position to switch the product on. The product
will automatically switch on or off at twilight
and charge the battery at daylight.
2. Switch the ON / OFF switch 5 in the OFF
position again to switch the product off.