Auriol H4286A Operation and Safety Notes

3

24.02.11 12:18

3

H4286A

H4286B

INDOOR / OUTDOOR THERMOMETER

Operation and Safety Notes

INOMHUS- / UTOMHUSTERMOMETER

Bruksanvisning och säkerhetsanvisningar

SISÄ- JA ULKOLÄMPÖMITTARI

Käyttö- ja turvallisuusohjeet

INDEN- / UDENDØRS TERMOMETER

Betjenings- og sikkerhetshenvisninger

24.02.11 12:18

GB / IE Operation and Safety Notes Page 4

FI Käyttö- ja turvaohjeet Sivu 22

SE Bruksanvisning och säkerhetsanvisningar Sidan 40

DK Brugs- og sikkerhedsanvisninger Side 57

24.02.11 12:18

3

A

1,5V AAA x 1

B

8

13

14

15

9

10

11

12

1

2

3

4

5

6

7

24.02.11 14:55

4 GB/IE

Introduction

Intended use ...........................................Page 5

Description of parts ................................Page 6

Technical data ........................................Page 7

Scope of supply ......................................Page 7

Safety notes .....................................Page 8

Battery Safety Instructions ......................Page 10

Getting started

Inserting / changing the battery .............Page 12

Positioning / installing the device ...........Page 13

Mounting the device on a wall ..............Page 15

Temperature memory .............................Page 16

Setting the time .......................................Page 17

Troubleshooting ......................................Page 18

Cleaning and Care ......................Page 19

Disposal ................................................Page 19

24.02.11 14:55

5 GB/IE

Indoor / outdoor thermometer



Introduction

Familiarise yourself with the product

before using it for the ﬁrst time. In

addition please refer carefully to

the operating instructions below and the safety

advice. Use the product only as described

and for the indicated purpose. Keep these

instructions in a safe place. If you pass the

product on to anyone else, please ensure that

you also pass on all the documentation.



Intended use

The thermometer measures the inside and

outside temperature in Celsius (°C). The main

unit is placed indoor, and sensor can be put

outdoor. The thermometer also displays the

highest and lowest measured temperature

and the time in 24-hour format. Other uses or

changes to the device are considered to be

contrary to the intended use and may result

24.02.11 14:55

6 GB/IE

in personal injury and / or damage to the

device. The manufacturer accepts no liability

for damage caused through the use of the

device in contradiction of its intended use.

The device is not intended for commercial use.



Description of parts

1

In / outdoor thermometer

2

“TIME” display

3

“IN” indoor temperature display

4

“OUT” outdoor temperature display

5

External sensor

6

“SET” button

7

MIN / MAX button

8

Stand

9

Battery compartment cover

10

Extension of battery compartment cover

11

Battery compartment

12

Hanger

13

Dowel

14

Screw

15

Self-adhesive pad

24.02.11 14:55

7 GB/IE



Technical data

Operating voltage: 1.5 V (DC)

Power supply: 1 x 1.5 V

AAA

battery (included)

Temperature range: Indoor: –10 °C to

+40 °C

Outdoor: –40 °C to

+60 °C

External sensor lead: approx. 2.8 m

Liquid crystal display: 21 x 50 mm



Scope of supply

Please check the supplied items immediately

after unpacking the device to ensure that

there is nothing missing and that the product

and all of its parts are in perfect condition.

Do not under any circumstances install the

product if the delivery scope is incomplete.

1 Indoor / outdoor thermometer

1 1.5 V

AAA battery

1 Dowel

1 Screw

24.02.11 14:55

8 GB/IE

1 Self-adhesive pad

1 Operating manual

Safety notes

KEEP ALL THE SAFETY ADVICE AND

INSTRUCTIONS IN A SAFE PLACE FOR

FUTURE REFERENCE!



DANGER

OF FATAL INJURY AND

ACCIDENTS FOR INFANTS

AND CHILDREN! Never leave children

unattended with the packaging material,

as it poses a risk of suﬀocation. Keep the

product out of the reach of children. The

product is not a toy.

 Children or anyone who does not have

the knowledge or experience to handle

the device, or anyone whose physical,

sensory or mental capacities are limited,

may only use the device under supervision

24.02.11 14:55

9 GB/IE

or instruction by a person responsible for

their safety. Children must be supervised to

ensure that they do not play with the device.

 Never dismantle the product. Improper

repair can cause signiﬁcant risks to the

user. Repairs must always be carried out

by a specialist only.

 Do not use the device if it is damaged.

Damaged devices represent a danger

of death from electric shock!

 Do not expose the device to

– extreme temperatures,

– strong vibrations,

– heavy mechanical loads,

– direct sunlight,

– moisture.

Otherwise there is a danger that the

device will be damaged.

 Do not expose the device to an extremely

high electromagnetic ﬁeld. This may impair

the correct functioning of the device.

24.02.11 14:55

10 GB/IE

 Please prevent the housing of the device

from rubbing to strongly against textiles.

This may result in static charges and aﬀect

the results of the measurements.

 Please note that the guarantee does not

cover damage caused by incorrect hand-

ling, non-compliance with the operating

instructions or interference with the device

by unauthorised individuals.

 Install the external sensor

5

outdoors so

that it is not exposed to direct sunlight.

 Take care that the mains lead is not

damaged on installation.



Battery Safety Instructions

 CAUTION! RISK OF EXPLOSION!

Never recharge the batteries. Have a

spent battery removed from the instrument

immediately. There is an increased risk of

leakage.

 Batteries must not be disposed of in

household waste.

24.02.11 14:55

11 GB/IE

 Consumers are under a legal obligation

to dispose of batteries in the proper way.



Keep the battery out of the reach of children,

do not dispose of the battery in ﬁre, do

not shortcircuit it, and do not take it apart.

 Failure to observe these instructions may

result in the battery discharging beyond

its end voltage, which poses a risk of

leakage. If the battery in your instrument

has leaked, have it removed immediately

to prevent damage to the instrument.

 Avoid contact with skin, eyes and mucous

membrane. In the event of contact with

battery acid, rinse the aﬀected area with

plenty of water and / or consult a doctor.

CAUTION! TAKE CARE NOT

TO DAMAGE THE PRODUCT!

 Only use the stated type of battery.

 Make sure that the polarity is correct.

 Check the battery regularly for signs of

leakage.

24.02.11 14:55

12 GB/IE

 Remove the battery if the device is not in

use for any length of time.

 Do not under any circumstances short-

circuit the terminals.



Getting started

 Remove the protective foil before ﬁrst use.



Inserting / changing

the battery

 Open the battery compartment

11

on the

back of the device by pulling the battery

compartment cover

9

up by its exten-

sion

10

oﬀ the battery compartment

11

(see Fig. B).

 Insert the supplied battery with the correct

polarity, or replace a spent battery with

a new one.

 Place the battery compartment cover

9

back on the battery compartment

11

to

close it.

24.02.11 14:55

13 GB/IE



Positioning / installing

the device

 CAUTION! When choosing a position

for the device, make sure that it is not exposed

to direct sunlight, vibrations, heat, cold damp

or dust. Do not install devices close to heat

sources, e.g. radiators. There is otherwise a

danger that the device will be damaged.

 Take care that the device is standing

safely on a stable surface.

 Take care that the device is suspended

properly if mounted on a wall. If the device

falls, it could cause injury or damage to

itself or other property.

 Place the device on a ﬂat, level surface.

 Do not place the device on valuable or sen-

sitive surfaces without suitable protection.

The surfaces may otherwise be damaged.

Stand:

 Open the stand

8

on the back of the

device to support the device.

24.02.11 14:55

14 GB/IE

Wall mount:

Note: you will need a drill for this step.

 CAUTION! DANGER TO LIFE,

RISK OF INJURY AND DAMAGE TO

PROPERTY! Please read the operating and

safety instructions for your drill carefully.

 Hold the device on the wall to ﬁnd a

suitable position for installation.

 Use a pencil if necessary to mark the

required position.

Ꮨ

DANGER OF ELECTRIC SHOCK! DAN-

GER OF DAMAGE TO PROPERTY!

DANGER OF INJURY! Ensure that

you do not strike electrical cables, gas or

water pipes when you are drilling into the

wall. If necessary, check the wall using a

suitable detector before you drill.

 Drill a suitable hole in the wall using an

electric drill.

 Push a suitable dowel

13

into the hole

and screw a screw

14

into the dowel

13

.

24.02.11 14:55

15 GB/IE

Ensure that the screw

14

is not completely

screwed into the dowel

13

.

 Hang the indoor / outdoor thermometer

from the screw

14

. To do this hook the

hanger

12

of the indoor / outdoor ther-

mometer on to the screw

14

.



Mounting the device

on a wall

 Pull the protective foil from one of the

sides of the self-adhesive pad

15

.

 Stick the self-adhesive pad

15

on to the

back of the device.

 Pull the protective foil from the other side

of the self-adhesive pad

15

.

 Take the device to the desired location

and press it carefully on to a wall or other

smooth surface.

Note: Wait 24 hours after installation until

using the device. This is to allow the self-adhe-

sive pad

15

to achieve an optimum level of

24.02.11 14:55

16 GB/IE

adhesion. After installation, do not change the

position of the self-adhesive pad

15

, otherwise

the level of adhesion achieved by the self-

adhesive pad could be reduced.



Temperature memory

 Press the MIN / MAX button

7

to show

the lowest temperature measured indoors,

“IN”

3

, and outdoors, “OUT”

4

.

 Press the MIN / MAX button

7

again to

display the highest measured temperature.

 Press the MIN / MAX button

7

again to

return to the current temperature.

Note: if the MIN / MAX button

7

is

not pressed for 5 seconds, the display

automatically reverts to the current

temperature.

Note: the stored minimum and maximum

temperature is deleted every day at

00:00 hours and measurement begins

again.

24.02.11 14:55

17 GB/IE



Setting the time

 Press the “SET” button

6

brieﬂy to begin

setting the hour. The hours in the “TIME”

display

2

ﬂash.

 Press the MIN / MAX button

7

to set the

hour.

Tip: keep the MIN / MAX button

7

pressed. This allows you to make the

settings faster. If you do not press any

button for 60 seconds, the LC display auto-

matically reverts to the standard display.

 Press the “SET” button

6

brieﬂy again

to begin setting the minutes. The minutes

in the “TIME” display

2

ﬂash.

 Press the MIN / MAX button

7

to set the

minutes.

 Press the “SET” button

6

brieﬂy again

to conﬁrm the set time.

Note: the set time is also conﬁrmed if no

button is pressed in a space of 1 minute.

Note: the thermometer now displays the

current time under “TIME”

2

, the inside

24.02.11 14:55

18 GB/IE

temperature “IN”

3

and the outside

temperature “OUT”

4

.



Troubleshooting

Note: the device contains sensitive electronic

components. It is therefore possible that radio

transmission devices in its immediate vicinity

may cause interference. Such devices include

e.g. mobile phones, two-way radios, CB radios,

radio controls / other remote controls and

microwaves.

 Remove any such device from the vicinity

of the indoor / outdoor thermometer if

errors occur on the display.

Note: electrostatic discharge may interfere

with operation.

 In the event of any malfunction, brieﬂy

remove the battery and replace it as

described under “Inserting / changing the

battery“.

24.02.11 14:55

Sidan laddas ...

Auriol H4286A Operation and Safety Notes

Denna manual är också lämplig för

Auriol H4286A Operation and Safety Notes

på andra språk

Relaterade papper

Andra dokument