9
EN
JUICE EXTRACTOR · JU1S-400/JU2S-800
ATTENTION BEFORE USE
NOTE: This machine is equipped with a safety unit, so if the handle is not in
position on the cover or the cutter part is not xed in place, the motor will not
start in order to ensure the safety of the user.
1. When disassembling or assembling the juicer, hold the top of the pusher bar
with your hand, then force the handle in or out of the slot.
2. Remove the cover then raise the middle ring by holding the juicing nozzle
with your hand, and lift up.
3. In order to avoid damage, before using, check the power supply and that it is
in compliance with the rating label.
4. Clean all parts except the main body (see maintenance and cleaning section).
5. Before assembling, please read the parts and contents section carefully.
6. Slide the foam separator into the juice jug. This keeps the foam away when
you pour the juice. The foam separator is only included with the JU2S-800
juicer.
USAGE
1. Before usage, please make sure that the button switch is set to “0”. This will
avoid starting the main machine if assembly is not completed, thus avoiding
unnecessary injury or damage to persons or property.
2. Before juicing, rst make sure that the strainer is set in the correct position,
with no direct contact between strainer and transparent cover. Put on the
transparent cover, secure the handle in the slot, and then turn on the machine.
3. In order to use, assemble according to the diagram in “Parts and contents”.
Plug the cable into a wall socket, turn the switch on and let the machine run
without load for 5 sec. Put prepared vegetable or fruit into the feeding chute
and press gently down with the food pusher.
NOTE: When pressing food with the food pusher, force must be even or indirect.
Pressure must not be more than 1 kg and do not use sudden force as the juicing
effect will be reduced.
OPERATING TIME
• This machine is designed with button switches marked O, I and II
(O for stop, I for low power, II for high power).
• For juicing, select high power, operate for 1 min, stop for 1 min, then repeat.
• After the above operation has been performed three times, stop for
15 minutes. Do not operate until the motor is cooled, as in this way the service
life of this machine will be prolonged.