EN
16
4. Open the lid by turning it anticlockwise
and put it beside the blender. Peel and
remove the cores from fruit and vegetables
and cut them into smaller pieces before
putting them in the container. Some liquid
should usually be added for the blender to
work smoothly. The amount of food must
not exceed the MAX marking, or be less
than the MIN marking on the container. A
suitable ratio between fruit/vegetables and
liquid is 2:3. Ingredients can be added to
the container through the opening in the
lid when the blender is running. Replace
the measure afterwards.
5. Put the lid on the container and turn it
clockwise.
6. Make sure that the control switch is in the
0 position.
7. Put the container on the motor unit and
turn it clockwise until it fastens in place.
The container has a safety function that
prevents the blender from working if the
container is not tted properly.
8. Plug the plug into the power point.
9. Set the control switch in the required
position to start the blender.
10. When in use the control switch can be
turned to pulse mode P to speed up the
blender.
FIG. 2
11. Turn the control switch to the 0 position
when the mixture has obtained the
required consistency.
12. Turn the container anticlockwise and lift
it o the motor unit, release the lid, and
serve from the container.
NOTE:
• Check that you have put the lid on
properly before starting the blender.
Never open the lid during use.
• Do not run the blender continuously for
more than 3 minutes, and wait until it has
cooled before using it again.
• The blender is not suitable for whisking
the whites of eggs, mashing potatoes,
mixing dough, or pressing juice from fruit
and vegetables.
• The blender cannot be used to crush ice.
MAINTENANCE
Cleaning the motor unit
1. Pull out the plug before cleaning.
2. Wipe the motor unit with a soft, damp
cloth.
NOTE:
• Do not use abrasive detergents, this can
damage the motor unit.
• Do not immerse the appliance in water or
any other liquid.
Cleaning the container
The blender’s automatic cleaning feature can
be used for quick and simple cleaning of the
container:
1. Pour lukewarm water and a little washing-
up liquid into the container, turn the control
switch to position 1, and run the blender for
a few seconds.
2. Remove the container from the motor unit
and rinse under running water.
3. Remove the blade unit from the container
and remove the measure from the lid.
Rinse the container, blade unit, lid and
measure under running water.
4. Wipe all the parts and replace them in the
reverse order.
NOTE:
Never dismantle the motor unit if a problem
occurs during use. The motor unit does not
contain any parts that can be repaired by the
user. Take it to an authorised service centre for
inspection and repair.