15
ENGLISH
INSTRUCTION MANUAL
It is best to use a large comb attachment first, and
then a smaller one, so you do not cut off too much
hair.
Start by cutting the person’s
hair so that it sits naturally.
Fix the largest comb attachment
to the hair clipper and start by
cutting the sides and the back
of the neck from the bottom
upwards. Hold the hair clipper
lightly against the hair, with the
flat side of the comb attachment
against the person’s head. Only
cut off a small amount at a time.
If you subsequently want to cut
the hair more closely, you can
either change to a smaller comb
attachment or carefully press
the clipper against the person’s
head.
You can cut the top using the
flat comb. Use it to comb the
hair up, and then run the hair
clipper over the comb.
You can also cut the top using
the actual comb attachment,
but be aware that even the
largest attachment leaves the
hair quite short. Cut from the
forehead towards the top of the
head or in the direction of the
hair growth.
Trimming
Comb attachments should not
be used when trimming the
sides, the back of the neck or
the area around the ears.
Set the blade control to close
cutting.
Comb the hair into the desired
style.
Hold the hair clipper between the person’s ear and
sideburns, with the blades close to the hairline.
Move the hair clipper along the hairline over and
behind the ear.
At the back of the neck and sides, you should hold
the hair clipper with the blades down and position
it on the required hairline. Now carefully push the
hair clipper down along the skin.
Blade control
The hair clipper is equipped with a blade control
so it can be set to various cutting lengths without
using the comb attachments. In the uppermost
position, the blade control provides close cutting,
which can be gradually increased when you turn
the blade regulator towards the bottom position.
Here the cutting length is approximately the same
as when using the smallest comb attachment.
By turning the blade control, you can also remove
any hair between the blades, as well as distribute
the oil along the blades when lubricating.
Short cutting with „flat top“
• Cut slowly upwards from the back of the neck
using the largest comb attachment.
• Cut the sides in the same way.
• Cut the top from the forehead and in the
direction of the hair growth by combing the
hair and then cutting it using the hair clipper.
• Comb the hair, trim the hairline and correct
any unevenness.
Short cutting with „tip“
• Cut the top using the largest comb
attachment.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Close cutting
Longer cutting