17
TR RO H SK CZ PL FIN S N P DK E NL I F D GB
3
Remove the outer foil
section and clean with
running water�
• See page 18 for removing the
outer foil section.
• Splashing is reduced by rinsing the shaver in sonic
vibration cleaning mode.
• After rinsing with water, shake the shaver up and
down for a few times to remove excess moisture and
then wipe off any drops of water with a dry cloth.
4
the shaver, and the
trimmer [A
• Allow the shaver to dry in the
shade, avoid direct sunlight.
5
Lubricate the shaver�
It will keep the movement of the
blade smooth and maintain a
comfort shave.
1. Apply one drop of oil to each of
the system outer foils.
2. Raise the trimmer and apply a drop of oil.
3. Switch the shaver on, and run it for approximately
4. Switch off the shaver, and wipe off any excess oil
from the system outer foil with a soft cloth.
Notes
• Be careful not to hit the main body on the sink or any
other object while draining the water. Failure to do so
may cause malfunction.
• Do not wipe with thinners, benzine, alcohol etc.
Doing so may cause malfunction, or cracking or
discoloration of the parts.
Wipe with diluted soapy water.
• Do not use any kitchen or bathroom detergents other
than hand soap.
Doing so may cause malfunction.
Cleaning with the brush
Remove the outer foil section and the inner blades.
(See page 18.)
Clean the system outer foil in the areas
indicated by the circles every time you
use the shaver.
Cleaning with the long brush
Clean the foil frame [A3],
system outer foil [A2], the
main body [A] and the
trimmer [A] using the
long brush.
Cleaning with the short brush
• Clean the inner blades [A]
using the short brush by moving
it in direction as illustrated.
• Do not move the short brush
perpendicularly against the
blades as it will damage the inner
blades and affect their sharpness.
ES-LV67_EU.indb 17 2019/06/05 19:10:20