NS-10MMF
SPEAKER SYSTEM
SYSTEME D’ENCEINTES
OWNER’S MANUAL
MODE D’EMPLOI
BEDIENUNGSANLEITUNG
G R
NS-10MMT PRE(02.8.20)a 02.8.28, 11:39 AM1
E-2
Read this before using the speaker.
●
To assure the finest performance, please read this manual
carefully. Keep it in a safe place for future reference.
●
Install the speaker in a cool, dry, clean place – away from
windows, heat sources, sources of excessive vibration,
dust, moisture and cold. Avoid sources of humming
(transformers, motors). To prevent fire or electrical shock,
do not expose the speaker to rain or water.
● To prevent the enclosure from warping or discoloring, do
not place the speaker where it will be exposed to direct
sunlight or excessive humidity.
● Do not place the following objects on the speaker:
Glass, china, etc.
If glass etc. falls by vibrations and breaks, it may cause
personal injury.
A burning candle etc.
If the candle falls by vibrations, it may cause fire and
personal injury.
A vessel with water in it
If the vessel falls by vibrations and water spills, it may
cause damage to the speaker, and/or you may get an
electric shock.
● Do not place the speaker where foreign objects such as
water drips might fall. It might cause a fire, damage to
the speaker, and/or personal injury.
● Do not place the speaker where it is liable to be knocked
over or struck by falling objects. Stable placement will
also ensure better sound performance.
PRECAUTIONS
The speaker is constructed with the majority of the weight
located in its upper portion, and is thus susceptible to falling
over if proper care is not taken to insure its stability. If the
speaker falls over, it may damage the speaker or be the
cause of injury (or even death) to persons and/or damage to
personal property.
For safe and proper use of the speaker:
• Position the speaker in a location that is solid, level,
smooth, and low (with respect to the floor).
• Do not push or apply pressure to the side of the speaker
when moving, or lean objects against the side of the
speaker.
• Do not sit on or set objects on top of the speaker.
Vibrations or jolts associated with earthquakes and other
phenomena or activities may cause the speaker to fall over.
For safety reasons, using commercially available products
that increase stability in the speaker is recommended
(metal fittings or chains, etc.).
PRECAUTIONS WHEN POSITIONING THE SPEAKERS
Thank you for selecting this YAMAHA NS-10MMF speaker system.
● Placing the speaker on the same shelf or rack as the
turntable can result in feedback.
● Never put a hand or a foreign object into the port located
on the rear of the speaker as this might cause personal
injury and/or damage to the speaker.
● When moving the speaker, do not hold the port as it
might cause personal injury and/or damage to the
speaker.
● Any time you note distortion, reduce the volume control
on your amplifier to a lower setting. Never allow your
amplifier to be driven into “clipping”. Otherwise the
speaker may be damaged.
●
When using an amplifier with a rated output power higher
than the nominal input power of the speaker, care should
be taken never to exceed the speaker’s maximum input.
●
Do not attempt to clean the speaker with chemical solvents
as this might damage the finish. Use a clean, dry cloth.
● Do not attempt to modify or fix the speaker. Contact
qualified YAMAHA service personnel when any service
is needed. The cabinet should never be opened for any
reasons.
● Secure placement or installation is the owner’s
responsibility.
YAMAHA shall not be liable for any accident caused
by improper placement or installation of the speaker.
E-1
NS-10MMF-Eng-B 02.8.28, 11:39 AM2
English
E-3
SPEAKERS
L
R
+
+
––
1
3
4
Before making connections, make sure that the
amplifier is switched off.
■ CONNECTIONS
• Connect the screw-type input terminals at the rear of the
speakers to the speaker output terminals of the amplifier
(or receiver) with the speaker cable.
• One side of the speaker cable is red and the other side is
black. Connect the (+) terminals on the amplifier (or
receiver) and speakers using the red side. Connect the
(–) terminals on both components using the black side of
the cable.
• Connect one speaker to the left (marked L) terminals of
your amplifier, and another speaker to the right (marked
R) terminals, making sure not to reverse the polarity
(+, –). If one speaker is connected with reversed polarity,
the sound will be unnatural and lack bass.
How to Connect:
1 Loosen the knob.
2 Remove the insulation coating at the extremity of each
speaker cable by twisting the coating off.
3 Insert the bare wire.
4 Tighten the knob and secure the cables.
Test the firmness of the connection by pulling lightly on
the cables at the terminal.
Speaker (R)
Speaker (L)
Note
Do not let the bare speaker wires touch each other as
this could damage the speaker or the amplifier, or both
of them.
When using a banana plug
<General model only>
1 Remove the cover by pulling it toward you.
2 Tighten the terminal knob.
3 Simply insert the banana plug into the terminal.
■ Using the non-skid pads
Put the provided non-skid pads at the four corners on the
bottom of speaker to prevent the speaker from moving by
vibrations etc.
Black
Red Red
Speaker output
terminals of the
amplifier (or
receiver)
CONNECTIONS TO YOUR AMPLIFIER
Non-skid
pad
2
3
Banana plug
1
Amplifier or
Receiver
Black Black
E-2
NS-10MMF-Eng-B 02.8.28, 11:39 AM3
E-4
PLACING THE SPEAKERS
■ Using as 2ch stereo speakers
Better stereo images will be obtained when the speakers
are slightly angled in towards the listeners.
■ Using as main speakers in a multi channel
system
Position the speakers on both sides of the TV. The
positioning of speakers is important, because it controls the
whole sound quality of a multi channel system. Set up the
speakers on the basis of your listening position by following
the owner’s manual supplied with your amplifier.
Note
This speaker features a magnetically shielded design,
but there is still a chance that placing it too close to a
TV set might impair picture color. Should this happen,
move the speaker away from the TV set.
Rear
Subwoofer
Center
NS-10MMF
NS-10MMF
REMOVING THE FRONT COVER
The front cover is fastened to the enclosure at six points
and can be removed if desired. To remove the cover, hold
on to both sides and slowly pull straight away from the
speaker. To reattach, line up the six holes on the inner
surface of the cover with the six corresponding pegs on the
speaker and push gently.
Note
When the cover is removed, take care not to touch the
speaker units with your hands or to exert excessive
force with tools.
SPECIFICATIONS
Type ................................2-way bass-reflex speaker system
Magnetic shielding type
Driver ................................... 9 cm (3-9/16”) cone woofer x 2
2.2 cm (7/8”) balanced dome tweeter
Impedance ...................................................................... 6 Ω
Frequency Response .................................. 55 Hz to 35 kHz
Nominal Input Power .................................................... 70 W
Maximum Input Power ................................................ 200 W
Sensitivity ..................................................... 86 dB/2.83 V/m
Crossover Frequency .................................................. 6 kHz
Dimensions (W x H x D) .................... 179 x 898.5 x 234 mm
(7-1/16” x 35-3/8” x 9-3/16”)
Weight .................................................. 9.8 kg (21 lbs. 9 oz.)
Accessories ................................................ Non-skid pad x 4
Speaker cable (4 m) x 1
●
Specifications subject to change without notice due to
product improvements.
●
Care should be taken not to exceed the input power
values noted above.
Rear center
E-3
NS-10MMF-Eng-B 02.8.28, 11:39 AM4
YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A.
YAMAHA CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADA
YAMAHA ELECTRONIK EUROPA G.m.b.H. SIEMENSSTR, 22-34, 25462 RELLINGEN, BEI HAMBURG, F.R. OF GERMANY
YAMAHA ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 77312 MARNE-LA-VALLEE CEDEX02, FRANCE
YAMAHA ELECTRONICS (UK) LTD. YAMAHA HOUSE, 200 RICKMANSWORTH ROAD WATFORD, HERTS WD1 7JS, ENGLAND
YAMAHA SCANDINAVIA A.B. J A WETTERGRENS GATA 1, BOX 30053, 400 43 VASTRA FRÖLUNDA, SWEDEN
YAMAHA MUSIC AUSTRALIA PTY, LTD. 17-33 MARKET ST., SOUTH MELBOURNE, 3205 VIC., AUSTRALIA
WA11170
Printed in Indonesia
HYOU-4 02.8.28, 11:40 AM2
-
1
-
2
-
3
-
4
-
5
på andra språk
- italiano: Yamaha NS-10MMF Manuale utente
- čeština: Yamaha NS-10MMF Uživatelský manuál
- español: Yamaha NS-10MMF Manual de usuario
- Deutsch: Yamaha NS-10MMF Benutzerhandbuch
- polski: Yamaha NS-10MMF Instrukcja obsługi
- português: Yamaha NS-10MMF Manual do usuário
- français: Yamaha NS-10MMF Manuel utilisateur
- Türkçe: Yamaha NS-10MMF Kullanım kılavuzu
- English: Yamaha NS-10MMF User manual
- dansk: Yamaha NS-10MMF Brugermanual
- русский: Yamaha NS-10MMF Руководство пользователя
- suomi: Yamaha NS-10MMF Ohjekirja
- Nederlands: Yamaha NS-10MMF Handleiding
- română: Yamaha NS-10MMF Manual de utilizare