CARRYING HOLDER for MARCHING SNARE DRUM
OWNER’S MANUAL
Thank you for purchasing the Yamaha MSH-420/220 Carrying
Holder for Marching Snare Drum.
Please read this Owner’s Manual throughly before use.
Printed in Japan
* MSH-420
2500411 R2
Once bolt positions have been determined,
tighten all bolts firmly. If the holder is used with
loose bolts, the instrument will be unstable while
playing and may suddenly overturn or drop
causing injury. It also may move about causing
unwanted noise. Before using the carrying
holder, check all bolts and firmly tighten any
loose bolts found.
Wing nuts should be tightened by hand only.
When removing the holder or removing the
instrument from the holder, do so gently. Do not
drop or throw the instrument.
Do not the stand in the rain. If the stand becomes
wet, use a soft dry cloth to wipe the stand as
soon as possible.
Always use a soft dry cloth to clean the stand as a
part of periodic maintenance. Never use thinner,
benzene, or other similar solvents to clean the stand.
CAUTION
Names of Parts
Snare Drum Mounting
Before assembling the carrying holder, check to make sure that all the
required parts have been provided.
Mount the snare drum by making the slide-attachment on the carrying holder slide
base. Tighten the clamp screw to secure the snare drum.
Holder (Upper)
Shoulder rests
Upright Frame (Upper)
Hexagonal Wrench
Holder (Lower)
Upright Frame (Lower)
Slide-attachment
Slide base
Clamp screw
Snare drum
Wrench